The hand wheel scale can be zeroed and is marked in degrees and 10 min divisions. It is calibrated in 5 deg increments around the rim. Bronze worm wheel and steel worm with 36: 1 ratio.

Overall Height is 1-1/2"
Center height when vertical is 1-1/2"

This new table has an extended base below the chuck so as to allow firm clamping of chuck at any position. This feature is only available from GARVIN Tools.

Features:

• The hand wheel scale which can be zeroed, is marked in degrees and 10min divisions.
• Bronze worm wheel and steel worm with 36:1 ratio.
• Gear meshing is adjustable to take up wear.
• Base is 145mm x 126mm
• Height when horizontal is 65mm
• Two 10mm Mounting holes for easy mounting
• Table is Graduated to 0-360 Degrees with 5Degree divisions
• Table has 4 T-Slots, 8mm wide
• Tilts accurately up to 90 Degrees with 1 Degree Increment

* Tailstock also available for this rotary table.

• Table can be used horizontally and vertically.
• Rigid, low profile design provides for two types of dividing:
  • Angular indexing - can be preformed through the graduated ring from 0 - 360 in increments of 1.
  • Manual indexing - you can disengage worm gear and rotate table plate by hand.
• Disengageable worm gear permits direct and manual indexing.
• Centre of the table has a MT2 hole.
• T-Slot width: .3150” (8mm).
• Worm gear ratio: 1 : 90.
• One full revolution of the crank wheel rotates the table for a 4 and 1’ at each increment.
• Centre Height - 2.7559” (70mm) in vertical position.
• Weight: 16.00 lbs.

See Current Special !

Features:

• Horizontal / Vertical Type 5859. Table can be used horizontally and vertically.
• Rigid, low profile, compact design provides for three types of dividing:
  • Angular indexing: can be performed through the graduated ring from 0° to 360° in increments of 1.
  • Rapid indexing: is done by means of a special dividing mechanism in divisions 2, 3, 4, 6, 8, 12 & 24 without any disassembly operations.
  • Indexing with the set of special dividing plates.
• Disengagable worm gear permits direct and rapid indexing.
• The table body is made of semi-steel.

Accuracy:

• Parallelism of clamping surface to base .0008"
• Flatness of clamping surface .0008"
• True running of MT center hole .0004"
• Squareness of clamping surface to base .0008"
• Indexing accuracy 1'

Standard Accessories: Two mounting bolts with nuts, Crank Wheel.